Figure 3-116: Snmp Community Strings; Mediant 600 & Mediant - AudioCodes Mediant 1000 User Manual

Parameter
IP Address
[SNMPManagerTableIP_x]
Trap Port
[SNMPManagerTrapPort_x]
Trap Enable
[SNMPManagerTrapSendingEnable_x]
3.4.1.1.2 Configuring the SNMP Community Strings
The 'SNMP Community String' page allows you to configure up to five read-only and up to
five read-write SNMP community strings, and to configure the community string that is used
for sending traps. For detailed information on SNMP community strings, refer to the Product
Reference Manual

To configure the SNMP community strings:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings''
2. In the 'SNMP Community String' field, click the right-pointing arrow
'SNMP Community String' page appears.
3. Configure the SNMP community strings parameters according to the table below.
4. Click the Submit button to save your changes.
SIP User's Manual
IP address of the remote host used as an SNMP
Manager. The device sends SNMP traps to these IP
addresses.
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to these ports.
The valid SNMP trap port range is 100 to 4000. The
default port is 162.
Activates or de-activates the sending of traps to the
corresponding SNMP Manager.

[0]

[1] Enable = Sending is enabled (default).
.
on page 189
Figure 3-116: SNMP Community Strings Page
192
Mediant 600 & Mediant 1000
Description
Disable = Sending is disabled.
.
button; the
Document #: LTRT-83306