System Log Save Mode Settings - D-Link DGS-3600 Series User Manual

Facility
UDP Port (514 or
6000-65535)
Status

System Log Save Mode Settings

The System Log Save Mode Settings window may be used to choose a method for which to save the switch log to the flash
memory of the Switch.
To view this window, click Administration > System Log > System Log Save Mode Settings, as shown below.
Use the pull-down menu to choose the method for saving the switch log to the Flash memory. The user has three options:
Time Interval – Users who choose this method can configure a time interval by which the switch will save the log files, in the box
adjacent to this configuration field. The user may set a time between 1 and 65535 minutes. The default setting is one minute.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates the facility values that the Switch is
currently employing.
Numerical Facility
Code
0 kernel messages
1 user-level messages
2 mail system
3 system daemons
4 security/authorization messages
5 messages generated internally by syslog line printer subsystem
6 network news subsystem
7 UUCP subsystem
8 clock daemon
9 security/authorization messages
10 FTP daemon
11 NTP subsystem
12 log audit
13 log alert
14 clock daemon
15 local use 0 (local0)
16 local use 1 (local1)
17 local use 2 (local2)
18 local use 3 (local3)
19 local use 4 (local4)
20 local use 5 (local5)
21 local use 6 (local6)
22 local use 7 (local7)
Type the UDP port number used for sending Syslog messages. The default is 514.
Choose Enabled or Disabled to activate or deactivate.
Figure 6- 18. System Log Save Mode Settings window
45