D-Link DGS-3600 Series User Manual page 42

Layer 3 gigabit ethernet managed switch
Hide thumbs Also See for DGS-3600 Series:
Table of Contents

Advertisement

MLD Snooping
RIP
DVMRP
PIM
OSPF
TELNET
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
The Switch's MAC address can also be found from the Web management program on the Switch Information (Basic Settings)
window on the Configuration folder.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be
automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
Starting at the command line prompt, enter the commands
Where the x's represent the IP address to be assigned to the IP interface named System and the y's represent the corresponding
subnet mask.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's represent the IP address to be
assigned to the IP interface named System and the z represents the corresponding number of subnets in CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask, and then be used to connect a
management station to the Switch's Telnet or Web-based management agent.
DGS-3627G:5#config ipif System ipaddress 10.73.21.33/255.0.0.0
Command: config ipif System ipaddress 10.73.21.33/8
Success.
DGS-3627G:5#
In the above example, the Switch was assigned an IP address of 10.73.21.33 with a subnet mask of 255.0.0.0. The user may also
use the CIDR form to set the address (10.73.21.33/8). The system message Success indicates that the command was executed
successfully. The Switch can now be configured and managed via Telnet and the CLI or via the Web-based management.
®
xStack
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled (TCP 23)
Figure 4- 4. Show switch command
config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy
Figure 4- 5. Assigning the Switch an IP Address
24

Advertisement

Table of Contents
loading

Table of Contents