User Account Management - D-Link DGS-3600 Series User Manual

Click Apply to implement changes made.
To view Web-based Access Control status of individual ports, click the
Use the pull-down menu to select the Switch in the switch stack and then the From and To fields to select a port or range of ports
to be viewed for their Web-based Access Control status. In the previous window, ports 1 to 5 have been selected to be viewed.

User Account Management

This window is used to set user accounts for the Web-based Access Control.
To view this window, click Security > Web Authentication > User Account Management, as shown below.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Control can be enabled.
NOTE: To enable the Web-based Access Control function, the redirection path field
must have the URL of the website that users will be directed to once they enter the
limited resource, pre-configured VLAN. Users which attempt Apply settings without
the Redirection Page field set will be prompted with an error message and Web-
based Access Control will not be enabled. The URL should follow the form
http://www.dlink.com
NOTE: The subnet of the IP address of the authentication VLAN must be the same
as that of the client, or the client will always be denied authentication.
NOTE: A successful authentication should direct the client to the stated web page.
If the client does not reach this web page, yet does not receive a Fail! message,
the client will already be authenticated and therefore should refresh the current
browser window or attempt to open a different web page.
Figure 11- 28. Web-based Access Control Port State window
Show Port State link to open the window seen below.
303