Figure 10- 17. Access Profile Entry Display window (Packet Content Mask)
To configure the Access Rule for IPv6, open the Access Profile Table window and click Modify for an IPv6 entry. This will open
the following window:
To remove a previously created rule, click its corresponding
®
xStack
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: When using the ACL Mirror function, ensure that the Port Mirroring
function is enabled and a target mirror port is set.
Figure 10- 18. Access Rule Table window (IPv6)
button. To add a new Access Rule, click the Add Rule button:
256