D-Link DGS-3600 Series User Manual page 84

The following parameters can set:
Parameter
User Name
Group Name
SNMP Version
SNMP V3 Encryption
Auth-Protocol by
Password / Key
Priv-Protocol by
Password / Key
To implement changes made, click Apply. To return to the SNMP User Table, click the
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 41. SNMP User Table Configuration window
Description
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP user.
This name is used to specify the SNMP group created can request SNMP messages.
V3 - Specifies that SNMP version 3 will be used.
SNMP v3 provides secure access to devices through a combination of authentication and
encrypting packets over the network. Use the drop down menu to select the type of SNMP
V3 encryption to be applied. The user can choose between None, Password or Key.
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This is only
operable when V3 is selected in the SNMP Version field and the Encrypted check box has
been ticked. This field will require the user to enter a password.
SHA - Specifies that the HMAC-SHA authentication protocol will be used. This is only
operable when V3 is selected in the SNMP Version field and the Encrypted check box has
been ticked. This field will require the user to enter a password between 8 and 16
alphanumeric characters.
None - Specifies that no privacy (encryption) protocol is in use.
DES - Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-56)
standard. This field is only operable when V3 is selected in the SNMP Version field and the
Encrypted check box has been ticked. This field will require the user to enter a password
between 8 and 16 alphanumeric characters.
Show All SNMP User Table Entries
66
link.