The following parameters can be set or displayed:
Parameter
Unit
From...To
Notification State
Admin Status
Port Description
System Name
®
xStack
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 7- 56. Basic LLDP Port Settings window
Description
Select the desired stacking unit, if applicable.
Select a port or group of ports using the pull-down menus.
Used to configure each port for sending notification to configured SNMP trap receiver(s).
Enable or disable each port for sending change notification to configured SNMP trap
receiver(s) if an LLDP data change is detected in an advertisement received on the port from
an LLDP neighbor. The definition of change includes new available information, information
timeout, and information update. In addition, the changed type includes any data update
/insert/remove.
Use the drop-down menu to choose: TX_Only, RX_Only, TX_and_RX, or Disabled.
Use the drop-down menu to toggle Port Description between Enabled and Disabled.
Use the drop-down menu to toggle System Name between Enabled and Disabled.
140