Port Access Control; Authenticator State - D-Link DGS-3600 Series User Manual

Port Access Control

The following windows are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the Port Access Control
windows, click monitoring > Port Access Control. There are six windows to monitor.

Authenticator State

The following section describes the 802.1X Status on the Switch. This window displays the Authenticator State for individual
ports on a selected device. A polling interval between 1 and 60 seconds can be set using the drop-down menu at the top of the
window and clicking OK.
To view the Authenticator State click Monitoring > Port Access Control > Authenticator State, as shown below.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: The Authenticator State cannot be viewed on the Switch unless
802.1X is enabled by port or by MAC address. To enable 802.1X, go to
the DGS-3600 Web Management Tool window.
Figure 12- 22. Authenticator State window (Port-based 802.1X)
348