D-Link DGS-3600 Series User Manual page 272

To remove a previously created rule, select it and click the
Figure 10- 16. Access Rule Configuration window (Packet Content Mask)
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter
Profile ID
Mode
Access ID (1-128)
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 15. Access Rule Table window (Packet Content Mask)
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set.
Type in a unique identifier number for this access. This value can be set from 1 to 128.
button. To add a new Access Rule, click the Add button:
254