Port Error Disabled - D-Link DGS-3600 Series User Manual

Parameter Description
From.... To Use the pull-down menus to select the port or range of ports to be configured.
State Toggle this field to either enable or disable a given port or group of ports.
Speed/Duplex
Toggle the Speed/Duplex field to either select the speed and duplex/half-duplex state of the port.
Auto denotes auto-negotiation between 10 and 100 Mbps devices, in full- or half-duplex. The
Auto setting allows the port to automatically determine the fastest settings the device the port is
connected to can handle, and then to use those settings. The other options are Auto, 10M/Half,
10M/Full, 100M/Half and 100M/Full, 1000M/Full_M and 1000M/Full_S. There is no automatic
adjustment of port settings with any option other than Auto.
The Switch allows the user to configure two types of gigabit connections; 1000M/Full_M and
1000M/Full_S. Gigabit connections only support full duplex connections and take on certain
characteristics that are different from the other choices listed.
The 1000M/Full_M (master) and 1000M/Full_S (slave) parameters refer to connections running
a 1000BASE-T cable for connection between the Switch port and other device capable of a
gigabit connection. The master setting (1000M/Full_M) will allow the port to advertise capabilities
related to duplex, speed and physical layer type. The master setting will also determine the
master and slave relationship between the two connected physical layers. This relationship is
necessary for establishing the timing control between the two physical layers. The timing control
is set on a master physical layer by a local source. The slave setting (1000M/Full_S) uses loop
timing, where the timing comes form a data stream received from the master. If one connection
is set for 1000M/Full_M, the other side of the connection must be set for 1000M/Full_S. Any
other configuration will result in a link down status for both ports.
Flow Control Displays the flow control scheme used for the various port configurations. Ports configured for
full-duplex use 802.3x flow control, half-duplex ports use backpressure flow control, and Auto
ports use an automatic selection of the two. The default is Disabled.
Learning Enable or disable MAC address learning for the selected ports. When Enabled, source MAC
addresses are automatically listed in the forwarding table. When learning is Disabled, MAC
addresses must be manually entered into the forwarding table. This is sometimes done for
security or efficiency. See the section on Forwarding/Filtering for information on entering MAC
addresses into the forwarding table. The default setting is Enabled.
Medium Type This applies only to the Combo ports. If configuring the Combo ports this defines the type of
transport medium used. SFP ports should be set at Fiber and the Combo 1000BASE-T ports
should be set at Copper.
Click Apply to implement the new settings on the Switch.

Port Error Disabled

The following window will display the information about ports that have had their connection status disabled, for reasons such as
STP loopback detection or link down status.
To view this window, click Administration > Port Configuration > Port Error Disabled, as shown below.
The following parameters are displayed:
Parameter
Port
State
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 9. Port Error Disabled Table window
Description
Displays the port that has been error disabled.
Describes the current running state of the port, whether enabled or disabled.
39