D-Link DGS-3600 Series User Manual page 237

Click the hyperlink VRID / Interface Name that you want to edit to display the following window:
This window displays the following information:
Parameter
Interface Name
VRID (1-255)
IP Address
State
Priority (1-254)
Advertisement
Interval (1-255)
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 74. VRRP Virtual Router Settings window
Figure 8- 75. VRRP Virtual Router Settings window
Description
Enter the name of a previously configured IP interface for which to create a VRRP entry.
This IP interface must be assigned to a VLAN on the Switch.
Enter a value between 1 and 255 to uniquely identify this VRRP group on the Switch. All
routers participating in this group must be assigned the same VRID value. This value MUST
be different from other VRRP groups set on the Switch.
Enter the IP address that will be assigned to the VRRP router. This IP address is also the
default gateway that will be statically assigned to end hosts and must be set for all routers
that participate in this group.
Used to enable and disable the VRRP IP interface on the Switch.
Enter a value between 1 and 254 to indicate the router priority. The VRRP Priority value may
determine if a higher priority VRRP router overrides a lower priority VRRP router. A higher
priority will increase the probability that this router will become the Master router of the
group. A lower priority will increase the probability that this router will become the backup
router. VRRP routers that are assigned the same priority value will elect the highest physical
IP address as the Master router. The default value is 100. (The value of 255 is reserved for
the router that owns the IP address associated with the virtual router and is therefore set
automatically.)
Enter a time interval value, in seconds, for sending VRRP message packets. This value
must be consistent with all participating routers. The default is 1 second.
219