Assembling / Disassembling The Front Wheel (3-Wheeler); Assembling / Disassembling The Front Fork (3-Wheeler); Replacing The Bearings (3-Wheeler) - Invacare Auriga Service Manual

Auriga
Invacare
®
Caution:
Either jack up the vehicle, and use appropriate supports (such as blocks of wood) to prop it up, or tilt
it over on its side. Make sure the front wheel(s) can revolve freely. Secure the vehicle against sliding or
falling over. Danger of injury!

9.5 Assembling / disassembling the front wheel (3-wheeler)

9.5.1 Assembling / disassembling the front fork (3-wheeler)

9.5.2 Replacing the bearings (3-wheeler)

•
Pull the de-clutching lever, jack up the vehicle, and
remove both bolts, which hold the wheel.
•
Remove the wheel from the fork.
Reassembly is done in reverse order.
•
Remove the seat and the rear shroud (see chapter 9.3.5).
•
Remove the steering column (see chapter 9.3.4).
•
Remove front shroud (see chapter 9.3.4).
•
Remove the eight-sided nut, the metal Gusset,
and the second eight-sided nut underneath it.
•
Lift the crash guard and pull the fork down and out.
Reassembly is done in reverse order.
•
Remove the seat and the rear shroud (see chapter 9.3.5).
•
Remove the steering column (see chapter 9.3.4).
•
Remove the front shroud (see chapter 9.3.4).
•
Remove the eight-sided nut, the metal Gusset,
and the second eight-sided nut underneath it.
•
Lift the crash guard and pull the fork down and out.
•
Pull the fork down and out, and replace the bearings.
Reassembly is done in reverse order.
Page 26
Service Manual