Sense Trigger Inputs - Elan System12 Installation Manual And User's Manual

SYSTEM12
INSTALLATION MANUAL
PS12 Rear Panel Connections
PS12 to VSE/VEHP Connections
It is possible to connect electronic volume controls to a PS12 without
using a PVSE Precision Panel as the following diagram shows.
IR, +12V, and GND are connected to the PS12.
PS12 to VSE/VEHP without PVSE Precision Panel
(speaker/amp connections not shown)
PS12 Precision Panel
Keypad (KP)
Connector
nc
Blue
IR
White/Blue
nc
Orange
485+
White/Orange
485-
Green
+12V
White/Green
GND
Brown
nc
White/Brown
Sense Trigger Input Connections
The Sense Trigger Inputs of the S12 are primarily for
use with VIA! Touch Panels. An ELAN™SENSE
®
Sensor can be connected that will cause VIA! Touch
Panels to execute IR or serial commands. Use
VIA! Tools setup software to set up Trigger Input func-
®
tionality. Wiring the Sense Inputs consists of punch-
ing down Voltage (V), Sense (S), and Ground (G) as
shown below.
ELANSENSE Sensors provide for a multitude of
automation requirements:
• Audio Sensor: Detects line-level audio
utilizing an RCA adaptor.
ELAN™SENSE Sensor to PS12 Sense Trigger Inputs
Page 26
(continued)
(No PVSE Precision Panel)
Cat-5
PS12
SENSE 6 SENSE 5
S G V G S G V G
AUDIO SENSOR
E L A N
Blue
White/Blue
ELAN
Orange
C45P
White/Orange
Green
White/Green
Brown
White/Brown
• Video Sensor: Detects Composite video
utilizing an RCA adaptor.
• Light/LED Sensor: Detects ambiant light or
multi-color LEDs.
• Contact Closure Sensor: Detects closed-
contact ON/OFF status.
• Current/Magnetic Sensor: Detects electrical
current through power cords or magnetic
flyback.
• Voltage Sensor: Detects 3-24 Volts AC or DC.
• Doorbell Sensor: Detects multiple doorbell
signals for advanced switching functionality.
SENSE 4 SENSE 3
SENSE 2
S G V G S G V G S G V
Red
Black
White
© ELAN Home Systems 2004 • All rights reserved.
H O M E S Y S T E M S
VSE or VEHP
SENSE 1
G S G V G