Diagnostic Start - Cisco catalyst 3750 Command Reference Manual

diagnostic start

diagnostic start
Use the diagnostic start user command to run the specified diagnostic test.
Syntax Description
switch num
test
test-id
test-id-range
all
basic
non-disruptive
Defaults
This command has no default settings.
Command Modes User EXEC
Command History Release
12.2(25)SEE
Usage Guidelines
Enter the
Enter the test-id-range as integers separated by a comma and a hyphen (for example, 1,3-6 specifies test
IDs 1, 3, 4, 5, and 6).
Examples This example shows how to start a diagnostic test on a specific switch:
Switch> diagnostic start switch 1 test 1
Switch>
06:27:50: %DIAG-6-TEST_RUNNING: Switch 1: Running TestPortAsicStackPortLoopback{ID=1} ...
(switch-1)
06:27:51: %DIAG-6-TEST_OK: Switch 1: TestPortAsicStackPortLoopback{ID=1} has completed
successfully (switch-1)
This example shows how to start diagnostics test 2 on a switch that will disrupt normal system operation:
Switch> diagnostic start switch 1 test 2
Switch 1: Running test(s) 2 will cause the switch under test to reload after completion of
the test list.
Switch 1: Running test(s) 2 may disrupt normal system operation
Do you want to continue? [no]: y
Switch>
Catalyst 3750 Switch Command Reference
2-126
diagnostic start switch num test {test-id | test-id-range | all | basic | non-disruptive}
Specify the switch number. The range is from 1 to 9.
Specify a test to run.
Identification number for the test to be run; see the "Usage Guidelines"
section for additional information.
Range of identification numbers for tests to be run; see the "Usage
Guidelines" section for additional information.
Run all diagnostic tests.
Run basic on-demand diagnostic tests.
Run the nondisruptive health-monitoring tests.
Modification
This command was introduced.
show diagnostic content command to display the test ID list.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07