Delivery And Dealer Service; Delivery Service; After The First 8 Hours - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Delivery and Dealer Service

Delivery Service

1. Fill the battery with battery acid and charge for four hours.
2. Fit the steering wheel, seat and, where applicable, other components.
3. Attach the cutting unit.
4. Adjust the cutting unit:
Adjust the lifting springs (the cutting unit's "weight" shall be 12-15 kg/26.5-33 lb; if a brush is to be
used, adjust to the maximum spring tension).
Adjust the cutting unit so that its rear edge is about 2-4 mm/1/8" higher than its front edge.
Adjust the cutting unit's cutting height setting so that the cutting height limit is 5 mm/3/16" above the
unit frame at the lowest cutting height.
5. Check that the right amount of oil is in the engine and transmission.
6. Check and adjust the air pressure in the tyres (60 kPa/0.6 bar/8.5 PSI).
7. Connect the battery.
8. Fill the fuel tank and start the engine.
9. Check that the machine does not move in neutral.
10. Check:
Driving forwards.
Reversing.
Engaging the blades.
The safety switch in the seat.
The safety switch in the lifting lever.
The safety switch for the hydrostat pedals.
11. Check the engine speed: 3,000 ±75 rpm.
12. Bleed the hydraulic system, top up with oil if necessary.
13. Inform the customer about:
The need and advantages of following the service schedule.
The need and advantages of leaving the machine for service every 300 hours.
The effects of service and maintaining a service journal on the machine's resale value.
Application areas for BioClip.
14. Fill in the sales papers, etc.

After the First 8 Hours

1. Change engine oil.
DELIVERY AND DEALER SERVICE
www.mymowerparts.com
7
English-