Replacing Bushings - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
6. Loosen the idler's spring (1) and pull off
the drive belt.
7. Remove the locking spring and loosen
the throttle control's link joint (2) (on the
underside), and remove the cable from
the underside of the shaft.
8. Loosen the cable from the neutral
position contact (5).
9. Loosen the brake cable's (3) spring and
nuts and pull off the cable from the brake
arm.
10. Loosen the cable to the differential lock,
see Removing/Mounting the Hydrostatic
Transmission on page 43.
11. Remove the circlip and washer from the
pendulum shaft (4) and pull loose the
rear frame.
12. Remove the circlip and washer from the
pendulum shaft's inner mount (1) and
pull the shaft out to the rear. Use a
sledgehammer or puller if needed.
If the dust cover (2) is damaged, it should be
replaced with a new one.

Replacing Bushings

Once the pendulum shaft is removed, replace
the bushings in the rear frame.
Remove these with a punch, seeSpecial
Tools on page 3.
New bushings are fitted with the punch
seeSpecial Tools on page 3 . Make sure that
the bushing grooves are lined up horizontally.
It is important that the outer bushing's outer
edge is on the same level as the outer edge
of the hole. The bushings should first be
lubricated with a lithium-based lubricant.
42
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
4
5
1
2
Steps 1-5
Pendulum shaft
Replacing bushings
3
8009-045
6012-031
8009-044