Adjusting Of The Hydrostatic Transmission Cable; Checking And Adjusting The Throttle Cable - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Adjusting of the Hydrostatic
Transmission Cable
The hydrostatic transmission cable (on the
left side) is adjusted in the following manner:
1. Remove the transmission cover. Loosen
both screws (one on each side) and lift
off the transmission cover.
2. Take apart the lower ball joint, which is
locked with a locking spring.
3. Ensure that the forward drive pedal is
pressed down completely.
4. Switch the vertical arm to the maximum
position and check that the ball and
socket in the lower ball joint are aligned.
5. Adjust the socket on the cable as
needed, so that it fits precisely over the
ball on the lever arm.
6. Assemble the lower ball joint.
7. Put the ball joint's locking spring in place.
8. Tighten the lock nut for the socket on the cable.
IMPORTANT INFORMATION
Make sure that the locking spring goes
through the hole in the socket.
Checking and Adjusting the
Throttle Cable
Check that the engine responds to throttle
increases and that a good engine speed is
attained at full throttle.
If adjustments are necessary, they can be
made as follows for the lower cable:
1. Loosen the clamping screw for the
cable's outer casing and move the
throttle to the full throttle position.
2. Check that the throttle cable is mounted
in the correct hole in the lower lever, see
illustration.
3. Push the throttle cable's outer casing as
far to the left as possible and tighten the
clamping screw.
38
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Transmission cover
Checking the adjustment of the
hydrostatic transmission cable
The link joint's locking spring
Throttle cable
6008-209
6020-002
8009-203
8009-176