Sharpening And Balancing Blades; Removing The Bioclip Plug (Combi) - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Sharpening and Balancing Blades

!
WARNING!
Protect your hands with gloves
when working with the blades.
1. Remove the blades as described in the
previous section.
2. Fix the blade in a vice and sharpen it
with a sharpening file.'
3. Balance the blade by:
• Attaching a punch, for example,
horizontally in the vice as shown.
• Thread the hole in the centre of the
blade over the punch and make sure that
the blade is equally weighted. The
illustration shows a blade that needs to
be adjusted, it must be filed more so as
to attain the right balance (at the arrow).
• Fit in the reverse order.
!
WARNING!
If the blades are cracked,
whether caused by poor repair
or other damage, they could
break while being used. The
risk increases if the blades are
poorly balanced.

Removing the BioClip Plug (Combi)

To change a Combi unit from the BioClip
function to a cutting unit with rear ejection,
remove the BioClip plug, which is located
under the unit, attached with three screws.
1. Put the unit in service position, see The
Cutting Unit's Service Position on
page 64.
2. Remove the three screws holding the
BioClip plug, and remove the plug.
3. Tip: Fit three full-thread screws M8x15
mm in the screw holes to protect the
threads.
4. Return the unit to the normal position.
Fit the BioClip plug in the reverse order.
70
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Sharpening blades
Balancing blades
Removing the BioClip Plug
6012-088
6012-089
8009-289