Delivery And Dealer Service; Delivery Service; After The First 8 Hours; After The First 50 Hours - Husqvarna Rider PR 17 Workshop Manual

DELIVERY AND DEALER SERVICE

Delivery and Dealer Service

Delivery Service

1. Fill the battery with battery acid and charge for
four hours.
2. Fit the steering wheel, seat and, where
applicable, other components.
3. Attach the cutting unit.
4. Check and adjust the air pressure in the tyres
(60 kPa/0.6 bar/9 PSI).
5. Adjust the cutting unit:
Adjust the lifting springs (the cutting unit's
"weight" shall be 12-15 kg/26,5-33 lb; if a
brush is to be used, adjust to the maximum
spring tension).
Adjust the cutting unit so that its rear edge is
about 2-4 mm/1/8" higher than its front edge.
Adjust the cutting unit's cutting height setting
so that the cutting height limit is 5 mm/3/16"
above the unit frame at the lowest cutting
height.
6. Check that the right amount of oil is in the
engine and transmission.
7. Connect the battery.
8. Fill the fuel tank and start the engine.
9. Check that the machine does not move in
neutral.
10. Check:
Driving forwards.
Reversing.
Engaging the blades.
The safety switch in the seat.
The safety switch in the lifting lever.
The safety switch for the hydrostat pedals.
11. Check the engine speed: 2900 ±75 rpm.
12. Bleed the hydraulic system, top up with oil if
necessary.
13. Inform the customer about:
The need and advantages of following the
service schedule.
The need and advantages of leaving the
machine for service every 300 hours.
The effects of service and maintaining a
service journal on the machine's resale value.
Application areas for mulching.
14. Fill in the sales papers, etc.

After the First 8 Hours

1. Change engine oil.
After the first 50 hours
1. Change the oil in the hydraulics and drive
system.

25-Hour Service

1. Clean the engine's cooling air intake and the
transmission's air intake.
2. Check the mounting bolts on the muffler.
3. Clean the fuel pump's air filter (for dusty
operating conditions).
50-Hour Service
1. Perform the 25-hour service.
2. Clean/replace the air cleaner's filter cartridge
(paper filter). (Shorter intervals for dusty
operating conditions.)
3. Check/adjust the cutting height.
4. Check/adjust the parking brake.
5. Inspect the flame proofing/spark arrestor
(extra equipment).
100/200-Hour Service
1. Perform the 25-hour service.
2. Perform the 50-hour service.
3. Change engine oil.
4. Check whether the engine oil filter needs
changing (every 200 hours).
5. Clean/replace the spark plugs.
6. Change the inline fuel filter.
7. Clean the cooling fins on the engine and the
transmission.
8. Check whether the oil or filter in the hydraulic
tank need changing (every 200 hours).
9. Check whether the hydraulic oil filter needs
changing (every 200 hours).
10. Clean the air filter's paper cartridge and check
whether it needs changing (every 200 hours).
11. Check nuts and screws for tightness.
15
English-