Removing/Fitting The Cable Pulley - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Removing/Fitting the Cable Pulley

1. Remove the frame plate.
2. Loosen the steering cables' rear mount (1).
3. Remove the screw (2) and remove the
cable pulley (5).
4. Remove the bearing's circlip (3) and tap
out the bearing (4).
5. To fit the cable pulley, follow the
instructions in the reverse order.
The screw (2) is to be mounted in the
rear hole on the frame. The bushing (6)
is to be placed between the frame and
the cable pulley.
Ensure that the cables are properly
situated under the steering cable rollers
(7) in the frame tunnel.
Hold the cables with, for example, an
adjustable wrench when mounting so
that they do not twist.
After mounting, the cable tension should be checked, see Checking and Adjusting the Steering Cables on
page 34.
Ensure that the steering wheel is in the centre position when the rear wheels are centred. Re-set the chain
on the power steering sprocket or adjust the rear fixture for the steering cables (1) as needed.
There is a complete assembly kit for sale for the Rider ProFlex that contains a cable pulley, bushings, and
bearings.
36
English-
REPAIR INSTRUCTIONS
Steering cables and cable pulley
www.mymowerparts.com
Steering cable's rear mount, left side
8009-358
8009-341