Husqvarna Rider ProFlex 21 II Workshop Manual page 63

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
4. Push the unit in so that the interior plugs
(B) touch the bottom of the equipment
frame's grooves.
5. Hook in the height adjustment handle's
(E) rear fastener:
Move the cutting height lever to the
forward position. Loosen the strut by
pulling the frame's forward section up or
down.
!
WARNING!
Watch your fingers. Do not turn the
blades or the belt.
6. Loosen the belt tensioner spring and
attach the belt to the front belt pulley. A
new belt is short. Turn the forward pulley
as needed with a spanner on the central
bolt.
7. Re-attach the belt tensioner spring.
IMPORTANT INFORMATION
Check that the belt is around the idler.
Belt Sketch
• 1. Drive belt
• 2. Forward pulley
• 3. Belt idler
• 4. Belt tensioner spring
8. Attach the nose cover.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Inner pins
E
Height adjustment handle
Belt tensioner spring
1
2
Belt sketch
8009-018
8009-168
8009-008
3
4
6016-105
61
English-