Fitting The Engine - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
12. Remove the engine fixtures, two on each
side of the engine, and remove the
engine from the rider.
The illustration shows the right side with
hydraulic cylinder fixture excluded. For
the left side, see the illustration under
Mounting.

Fitting the Engine

IMPORTANT INFORMATION
When fitting the engine, it is impor-
tant that the belt pulley's groove (1) is
in such a position that the outgoing
shaft's key (2) fits into the groove
(see illustration). Also check that
both the spacing tube (3) and key (2)
are well fitted to the engine shaft.
Grease the engine shaft.
1. Lower the engine into place and tighten
the engine fixtures (two on each side of
the engine) with a torque of 25 Nm/18 lbf.
ft.
The battery's negative cable should be
attached to the forward left screw. The
hydraulic cylinder fixture should be
attached to the forward right screw.
2. Fit the belt pulley with tool no. 506 56 06-
01 and tighten with a torque of 80 Nm/56
lbf. ft. Use tool no. 506 89 92-01 to
counter.
Place both belts in place on the belt
pulley.
REPAIR INSTRUCTIONS
www.mymowerparts.com
The engine's fastening screws,
right side. Mount not shown
Engine shaft and belt pulley
Engine mount screws and negative cable
506 56 76-01
Engine belt pulley
8009-192
6019-039
8009-365
8009-194
29
English-