Husqvarna Rider ProFlex 21 II Workshop Manual page 53

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
4. Tighten the hydrostatic transmission
cable clamp. Press the link joint onto its
fastener and attach the locking spring.
5. Attach the link joint to the rear part of the
hydrostatic transmission cable. Screw
10-12 turns so that the link joint has the
right length.
6. Run the hydrostatic transmission cable
along with the other cables. Place the
hydrostatic transmission cable in the
cable holder under the articulated
steering's bearing.
7. Place the hydrostatic transmission cable
in place and screw it in place with the
rear clamp under the left drive shaft.
8. Adjust the hydrostatic transmission cable
as shown, see Adjusting of the
Hydrostatic Transmission Cable on
page 38.
9. Connect the rear link joint and attach the
locking spring.
Locking spring
10. Tighten the rear link joint's lock nut.
REPAIR INSTRUCTIONS
8009-203
www.mymowerparts.com
Front clamp
Rear link joint
Cable holder
Adjusting the hydrostatic
transmission cable
6019-024
6019-025
6019-364
6020-002
51
English-