Husqvarna Rider ProFlex 21 II Workshop Manual page 49

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
9. Remove the insulation tape from the
shaft and repeat the entire procedure as
needed for the other shaft.
10. Replace the washer, spacing tube, key,
hub, circlip, hubcap, and rear wheel.
11. Fill the transmission's oil tank with
SAE 10W/30 engine oil until the level
reaches the MAX mark.
12. Bleed the hydraulic system of excess air.
13. Run the rider and make sure that there
are no oil leaks from the new shaft seals.
14. Check the oil level after test running and
top up as needed.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Transmission oil tank 6012-048
47
English-