Power Supply Preparations; Using A Battery Pack - Sony SRW-1 Operation Manual

3-4 Power Supply
Preparations
This system can be used with a battery pack or AC power.
This section explains how power is supplied when this unit
is used in an integrated SRW-1/SRPC-1 system.
When the SRW-1 is docked on the F23/F35, power is
supplied from the F23/F35.
For details on operations about the F23/F35, refer to the
F23/F35 Operation Manual. Contact a Sony service or
sales representative for details on the F23/F35.
Note
For safety, use only the Sony battery packs and AC
adaptors listed below.
• BP-GL95 Lithium-ion Battery Pack
• AC power using the AC-DN10/DN2B AC Adaptor

3-4-1 Using a Battery Pack

The battery pack usable with this system is the BP-GL95.
Before use, charge the battery pack with the special battery
charger.
Detach the battery pack if you will not be using the system
for an extended period of time.
Refer to the operation manual of the battery charger for
more information about how to charge battery packs.
To attach a battery pack
1
While pressing in the lock release button on the battery
attachment section of SRPC-1, slide the battery
connector cover to remove it. (See the figure in the
next item, "To detach a battery pack".)
2
Align the line on the battery attachment section of the
SRPC-1 with the line on the side of the battery pack.
34

3-4 Power Supply Preparations

3
Slide the battery pack down until its LOCK arrow
points at the matching line on the SRPC-1.
To detach a battery pack
While pressing the lock release button on the battery
attachment section, slide the battery pack in the direction
opposite to the direction in which you attached it.
Note
Compared to equipment such as the HDW-F900R
camcorder, the battery attachment section of the SRPC-1 is
closer to the ground.
For this reason, you should be careful when moving the
system with a battery pack attached as shown in the above
Battery pack
Align these lines.
Arrow mark
Line on SRPC-1
Lock release button