Sony SRW-1 Operation Manual page 58

Item
SERVO
REC INHI
Record inhibit settings
58
4-5 SYSTEM Setup Menu
STBY OFF
TRACKING
ADJUST
EOS MODE
REC REVIEW
Settings
Sets the time after the tape stops until the system enters tape
protect mode (still timer).
1sec [1sec]: After 1 second
5sec [5sec]: After 5 seconds
10sec [10sec]: After 10 seconds
20sec [20sec]: After 20 seconds
30sec [30sec]: After 30 seconds
40sec [40sec]: After 40 seconds
50sec [50sec]: After 50 seconds
1min [1min]: After 1 minute
2min [2min]: After 2 minutes
3min [3min]: After 3 minutes
4min [4min]: After 4 minutes
5min [5min]: After 5 minutes
6min [6min]: After 6 minutes
7min [7min]: After 7 minutes
8min [8min]: After 8 minutes
30min [30min]: After 30 minutes
UNITY [Unity]: Disable tracking control during playback.
VARI [Variable]: Allow manual tracking control during playback.
AUTO [Auto]: Automatically optimize tracking control during
playback.
Sets the tracking value when TRACKING is set to "VARI".
–15 to +15 (0)
NORM [Normal]: When the FUNC + PLAY buttons are pressed
with tape transport stopped, the unit rewinds for about five
seconds and then plays for about 10 seconds. If the
recording end point is located in that section, playback stops
at that point and the unit enters recording pause mode. If the
recording end point is not located in that section, playback
continues for about 10 seconds and then stops.
LONG [Long]: The 10-second search time limit described above
does not apply. Once playback starts, the search continues
until the recording end point is found.
NORM [Normal]: Pressing the FUNC+PLAY buttons once
rewinds tape approximately 3 minutes, and then starts
playback. Holding down the FUNC+PLAY buttons rewinds
tape for the seconds (up to the position 10 seconds before)
according to the duration which these buttons are held down,
and playback starts.
ALL [All]: Pressing the FUNC+PLAY buttons once rewinds tape
to the beginning of the cut recorded last and plays back the
cut.
OFF [Off]: Do not inhibit recording.
ON [On]: Inhibit recording