Sony SRW-1 Operation Manual page 18

The timecode output is determined by the setting of
OTHERS (MAIN) >TC OUT in the TC Setup menu as
follows.
TCG (timecode generator): Timecode generated by the
timecode generator is output, delayed by 1 frame.
(This maintains synchronization with the output
video).
AUTO: During recording (including E-E mode), timecode
generated by the timecode generator is output, delayed
by 1 frame. (This maintains synchronization with the
output video).
During playback, the LTC signal read from the tape is
output.
THRU: Timecode input to the TC IN connector is through
output.
TCG (No Delay): Timecode generated by the timecode
generator is output, with no delay. (The timecode is
out of synchronization with the output video, being 1
frame in advance of the video.) Select this setting
when you want to synchronize other devices, using the
timecode generator of this unit as the master.
e POWER ON/OFF switch
When the SRPC-1 power is on, push this switch up to the
ON side to power the SRW-1 on. To power the SRW-1 off,
push the switch down to the OFF side.
Normally leave this switch on the ON side since the SRW-
1 is powered on and off automatically by the SRPC-1
POWER ON/OFF switch.
f AUDIO INPUT CH-1 and CH-2 (analog audio
input channels 1 and 2) connectors (XLR 3-pin,
female) and input selection switches
These connectors allow up to four channels of analog
audio signals to be input from microphones and other
external audio devices.
Set the input selection switches as follows, depending on
the type and level of the input audio.
LINE: For line input
MIC: For microphone input
+48V ON: For input from microphones with external
power supply
18
2-1 SRW-1