Warning Messages - Sony SRW-1 Operation Manual

Warning messages

Code
a)
SRW-1 warning SRPC-1 warning
0001 —
0004 —
0005 —
0007 —
0008 —
0009 0109
000C 010C
000E 010E
000F —
— 010F
0010 —
0011 —
0013 —
0014 —
0015 —
0016 —
0017 —
— 0121
0022 0122
— 0124
— 0125
— 0126
— 0128
— 012C
— 012D
0030 0130
0032 0132
Message
b)
PB FREQ MISMATCH
NO PB LTC
NO PB VITC
REC INHIBIT MODE
INVALID FMT CONV
TEMPERATURE LOW
DC VOLTAGE LOW
TEMPERATURE HIGH
VA MISSING
VTR MISSING
TELEFILE FULL
TELEFILE NO ROOM
TELEFILE FMT NG
TELEFILE RD FAIL
TELEFILE WR FAIL
TELEFILE WR INHI
NO TELEFILE LABE
PD PLL UNLOCK
AUDIO PLL UNLOCK
NO HD REF
NO SD REF
HD&SD REF ASYNC
REF SEL NOT GOOD
BAD HD REF
BAD SD REF
NO SDI INPUT
INVALID SDI DATA
Description
System frequency of this system does not match
system frequency on the tape.
Playback LTC cannot be detected.
Playback VITC cannot be detected.
The system cannot record because of a record
inhibit menu setting. Or the tape is not formatted for
recording.
Format conversion is not possible with the current
settings.
The temperature inside the unit is lower than the
specified values.
DC voltage has fallen below the specified level.
The temperature inside the unit has risen.
SRPC-1 is not connected.
SRW-1 is not connected.
Telefile memory is almost full. The next recording will
erase existing data, beginning with oldest.
Free memory in a Telefile has been completely
exhausted.
Telefile format is invalid in 1 or more locations.
Telefile read failure occurred.
Telefile write failure occurred.
Attempt to record was made when entire Telefile is
write inhibited.
Telefile could not be recognized.
The pull-down PLL could not be locked on the
selected reference signal. Input a correct reference
signal. Pull-down output is not supported for the
24PsF format. In this case, set REFERENCE
>MODE in the SYSTEM Setup menu to "Input", or
after setting it to "EXT" set REFERENCE
>EXTERNAL to "HD".
Audio clock generator PLL is not locked to reference
video signal.
No HD reference signal is being input, even though
REFERENCE >EXTERNAL in the SYSTEM Setup
menu is set to HD or HD&SD.
No SD reference signal is being input, even though
REFERENCE >EXTERNAL in the SYSTEM Setup
menu is set to HD&SD or SD.
HD reference signal and SD reference signal are not
synchronized, even though REFERENCE
>EXTERNAL in the SYSTEM Setup menu is set to
HD&SD.
Reference signal selection is invalid.
HD reference signal is invalid.
SD reference signal is invalid.
When the optional HKSR-101 is installed, there is no
valid input to the selected VIDEO I/O connector.
SDI input signal data is invalid.
Error Messages and Warning Messages
107