Using The Control Panel Extension Cable - Sony SRW-1 Operation Manual

5
Lift the SRW-1 off the SRPC-1.
6
Move the assist lever to the lock position.
3-1-2 Using the Control Panel
Extension Cable
When they are shipped from the factory, the control panel
and SRW-1 are connected by a short cable. You can
replace this cable with the supplied extension cable, which
allows you to use the control panel apart from the SRW-1.
Proceed as follows.
1
Disconnect the short cable from the CTRL PANEL
connector on the SRW-1. (See the following figure.)
2
While pressing the lock release button next to the
control panel, slide the control panel in the direction of
the arrow in the figure to separate the control panel
from the SRW-1 body.
24
3-1 Assembly
Lock release button (for control panel)
Release knob
Assist lever
3
Remove the cable from the control panel and replace it
with the extension cable.
4
Connect the extension cable to the CTRL PANEL
connector on the SRW-1.
To secure the extension cable with the cable
clamp
You can attach the cable clamp supplied with the SRW-1
to secure part of the extension cable. Proceed as follows.
1
Remove the two screws from the SRW-1. (See
following figure.)
2
Attach the supplied cable clamp to the SRW-1 using
the screws removed in step 1.
Remove cable