Sony SRW-1 Operation Manual page 21

q CAMERA REMOTE IN (remote control input)
connector (8-pin)
When the optional HKSR-101 Optical Interface Unit is
installed, you can connect an RM-B750/B150 Remote
Control Unit to this connector.
r EXT DC SELECT (external power selection)
switch
Select the operating mode when an external power supply
is connected.
AUTO: Normally use the external power supply
connected to the DC IN connector, but when its
voltage declines, automatically switch to the power
supply attached to the battery attachment section.
EXT (external): Always use only the external power
supply connected to the DC IN connector.
s DC IN connector (XLR 4-pin, male)
When using the optional AC-DN2B/DN10 AC Adaptor to
connect to an AC power source, connect the DC power
cord of the adaptor to this connector.
Use only the DC power cord supplied with the AC adapter.
t CAMERA connector (optical-fiber connector)
(when HKSR-101 installed)
Connect the F23/F35 Digital Cinema Camera by FC2-
PD50/PD250 Optical-Fiber Cable (optional).
A single optical-fiber cable can send and receive audio and
control signals multiplexed into video signals.
Refer to the HKSR-101 Installation Manual for
information about installing the HKSR-101.
Notes
• Power cannot be supplied from this unit to a camera over
optical-fiber cable.
• Communications errors can occur if dust accumulates on
the surface of the connector of the optical-fiber cable.
Always clean the CAMERA connector before use.
Whenever the CAMERA connector is not in use, always
cover it with the cap supplied with the HKSR-101.
Refer to the HKSR-101 Installation Manual for
information about cleaning the optical-fiber connector.
u POWER (power supply) indicator
Lights in green when the SRPC-1 is powered on. Flashes
when the SRW-1 is put into power save mode by the
setting of SAVE MODE in the SYSTEM Setup menu to
"SAVE".
For more information about SAVE MODE, see page 60.
v Info (information) indicator
Normally not used.
21
2-2 SRPC-1