Power Supply Preparations; Using A Battery Pack; Using Ac Power - Sony SRPC-1 Operation Manual

3-4 Power Supply
Preparations
This system can be used with a battery pack or AC power.
This section explains how power is supplied when this unit
is used in an integrated SRW-1/SRPC-1 system.
When the SRW-1 is docked on the F23, power is supplied
from the F23.
For details on operations about the F23, refer to the F23
Operation Manual. Contact a Sony service or sales
representative for details on the F23.

3-4-1 Using a Battery Pack

The battery pack usable with this system is the BP-GL95.
Before use, charge the battery pack with the special battery
charger.
Detach the battery pack if you will not be using the system
for an extended period of time.
Refer to the operation manual of the battery charger for
more information about how to charge battery packs.
To attach a battery pack
1
While pressing in the lock release button on the battery
attachment section of SRPC-1, slide the battery
connector cover to remove it. (See the figure in the
next item, "To detach a battery pack".)
2
Align the line on the battery attachment section of the
SRPC-1 with the line on the side of the battery pack.
3
Slide the battery pack down until its LOCK arrow
points at the matching line on the SRPC-1.
To detach a battery pack
While pressing the lock release button on the battery
attachment section, slide the battery pack in the direction
opposite to the direction in which you attached it.
Note
Compared to equipment such as the HDW-F900R
camcorder, the battery attachment section of the SRPC-1 is
closer to the ground.
For this reason, you should be careful when moving the
system with a battery pack attached as shown in the above
figure, to prevent the bottom of the battery pack from
striking the ground, which may cause it to come off.

3-4-2 Using AC Power

The AC adaptors usable with this system are the AC-
DN10/DN2B.
Battery pack
Both adaptors are supplied with DC power cords, which
are connected to the DC IN connector on the rear panel of
the SRPC-1.
Align these lines.
The AC-DN10/DN2B can also be attached to the battery
attachment section of the SRPC-1.
To attach the AC-DN10/DN2B
Refer to "To attach a battery pack" (page 35) and attach in
the same way.
Arrow mark
Line on SRPC-1
Lock release button

3-4 Power Supply Preparations

35