Back Button - Sony SRW-1 Operation Manual

TC button: Displays the TC (timecode) Setup menu (see
page 46). This menu allows you to switch between
LTC and VITC, to switch between DF and NDF, and
to display timecode on an external monitor.
VIDEO button: Displays the VIDEO Setup menu (see
page 50). This menu allows you to make settings
related to video.
AUDIO button: Displays the AUDIO Setup menu (see
page 52). This menu allows you to make settings
related to audio.
SYSTEM button: Displays the SYSTEM Setup menu
(see page 54). This menu allows you to make settings
related to the entire systems, such as recording format,
power, and test signal output.
See Chapter 4 "Menu Settings" (page 44) for more
information about menus.
b Display
Displays menus, audio levels, warning, operating status,
time data, remaining tape time, and remaining battery
power.
For details, see 2-1-3 "Display" (page 15).
c KEY INHI (inhibit) switch
When the KEY INHI item (see page 57) in the SYSTEM
Setup menu is set to ALL, setting this switch to ON
disables operation buttons, to prevent misoperations due to
accidental button operations.
Name
STOP button
12
2-1 SRW-1
Pressed alone
Stops tape transport.
Pressing this button while in standby on
mode resets the still timer (see page
58).
Pressing the button while in standby off
mode puts the SRW-1 into standby on
mode.
ON: All operation buttons are disabled.
OFF: During recording, only the STOP button and
PAUSE button are enabled. All buttons are enabled
when the system is not recording.
When the KEY INHI item in the SYSTEM Setup menu is
set to MAP, the operation buttons follow the settings of the
LOCAL KEYMAP item.
d LIGHT switch
The backlight comes on when this is set to ON.
e ADJUST knob
Use to adjust audio levels, etc.
f SELECT/ENTER dial
When a menu is displayed, you can rotate this dial to move
the cursor, and press it to change and confirm settings.
g BACK button
When a menu is displayed, you can press this button to
back up one level in the menu structure.
h Control panel connection cable
Connect to the SRW-1 CTRL PANEL connector.
i Tape transport control buttons
Use these buttons for tape transport operations.
The functions of the buttons change when they are pressed
together with the FUNC button.
Pressed with FUNC button
Puts the SRW-1 into standby off mode.