Operation Flow; Target Frame Frequencies And Signal Formats - Sony SRW-1 Operation Manual

when the specified amount of data has been transferred.
Recording proceeds by repeating this series of operations.
You can check the amount of data stored in the memory of
the HKSR-102 with the numeric value and bar graph
shown in the MEM: area at the bottom of the control panel
display.
00 26
H
SYS : 1080 S59P(23PsF) 4:2:2
FPS : 8 / 8 F R M ( M O D E : V T R )
MEM : 2 1 %
Notes
• During recording, data transfer to the tape starts when
you press the STOP button or PAUSE button to stop or
temporarily stop the recording. The tally indicator on the
rear side of this unit flashes four times per second during
data transfer. Be sure not to power off this unit until the
data transfer to the tape is complete.
• Tape recording is not performed until the amount of data
stored in the memory exceeds the specified value.
• Input data is not recorded while the bar graph shows 0%.
Playback of tapes recorded with SR Motion
When you play a tape that was recorded with SR Motion,
the FPS value in SR Motion recording is shown in the
playback frequency position of the PB line.
00 00
H
SYS: 1080 S23PsF(23Psf) 444SQ
PB : 1080 23PsF(S59)30.000 422
MON: 1080 59.94I/525 59.94I

7-1-2 Operation Flow

The operation flow is shown below.
Connect the unit to the camera
Set the target frame frequency
(playback timecode)
Select the system signal format to use
during shooting
Select an SR Motion mode (function)
Set the number of frames to shoot
Shoot the scene
Review
02 12
M S F
50min
12.8V
00 00
M S F
IN: --:--:--:--
44min
12.8V
FPS value
r
r
r
r
r
r
7-1-3 Target Frame Frequencies and
Signal Formats
The following table shows the combinations of target
frame frequencies and signals formats that are required for
SR Motion shooting.
81
7-1 Overview