Superimposed Text Information; Operating Mode - Sony SRW-1 Operation Manual

3-6 Superimposed Text
Information
Timecode, operating modes, warning/error messages, and
other text information can be superimposed on the video
signals output from the MONITOR OUT HD SDI and SD
SDI connectors of the SRPC-1.
Use the TC Setup menu to specify whether to superimpose
this information, and to select the position and type of the
superimposed text. Select the menu item CHAR(MON)
(see page 48) to make settings for text information output
from the MONITOR OUT HD SDI connector, and select
the menu item CHAR(SD) (see page 49) to make settings
for text information output from the MONITOR OUT SD
SDI connector.
Information displayed
1Monitor output format
Time data
1 0 8 0 2 3 . 9 8 P s F
T C R . 1 2 : 3 4 . 5 6 . 0 1 *
P L A Y L O C K
4Operating
mode of
this system
3Time data type
5Timecode reader drop-frame mark
a Monitor output format
Displays the format of each video signal output from the
MON OUT HD SDI connector and the MON OUT SD SDI
connector. (This is not the system format.)
The display disappears after a few seconds whenever the
unit is in any of the following states.
• When the unit is powered on after changing the system
format
• Immediately after pressing the REC button to enter E-E
mode
• Immediately after changing the VIDEO >MON SEL(x2)
>TYPE setting to "Link A" or "Link B"
• Immediately after setting VIDEO >DC >PD(MON) to
"AUTO" or "THRU" (only when the operating frame
frequency is 23.98PsF)
b Tape remaining
The remaining tape capacity is displayed as follows.
2Tape remaining
( A )
R 1
1 3 . 5 V
8Battery voltage
7VITC field mark
6Timecode generator drop-frame
mark
Display of remaining tape time when it is 23 minutes or less
T C R . 2 3 : 5 9 : 4 0 : 1 8
Display of remaining tape time when it is 5 minutes or less
T C R . 2 3 : 5 9 : 4 0 : 1 8
c Time data type
Display Meaning
CTL CTL counter data
TCR LTC reader timecode data
UBR LTC reader user bit data
TCR. VITC reader timecode data
UBR. VITC reader user bit data
TCG Timecode generator timecode data
UBG Timecode generator user bit data
When timecode and user bit data cannot be read correctly,
asterisks (*) are displayed in these blocks, for example as
"T*R", "U*R", "T*R.", and "U*R.".
d Operating mode
The information displayed is divided as shown in the
following figure into blocks A and B.
Block A: Operating mode
Block B: Servo lock state or tape speed
A
The following modes are shown in the operating mode
display.
"SYSTEM READY"
"CASSETTE OUT"
"STANDBY OFF"
"REC"
"REC LOCK"
"REC PAUSE"
"PLAY"
"PLAY LOCK"
"PLAY PAUSE"
"F.FWD"
"REW"
"TAPE UNTHREAD"
"STOP"
e Timecode reader drop-frame mark (525-line mode
only)
" . ": Drop-frame mode
" : ": Non-drop frame mode
R 2 3
R 5
B

3-6 Superimposed Text Information

37