Video Setup Menu - Sony SRW-1 Operation Manual

4-3 VIDEO Setup Menu

The VIDEO Setup menu allows you to make settings
related to video signals.
In the Settings column of the following table:
• Factory default settings are underlined.
• Square brackets indicate settings as displayed in setting
windows (see the figure for step 3 on page 62).
Item
PD(MON) OUTPUT
DC TYPE
POS(EC)
MON SEL(x2) TYPE
BORDER
BORDER
LEV
VIDEO I/O VA INPUT
CAM TYPE Selects the type of camera which can be connected with an optical-fiber cable, when CAM is
50
4-3 VIDEO Setup Menu
Settings
Selects whether to perform pulldown conversion of output to the MONITOR OUT HD SDI
connector
AUTO [Auto]: Convert when the frame frequency is 23.98 Hz. Otherwise, do not convert.
THRU [Through]: Do not convert.
Selects the downconvert mode.
LB [Letter Box]: Letter Box mode
EC [Edge Crop]: Edge Crop mode
SQ [Squeeze]: Squeeze mode
When TYPE is set to EC, adjusts the H crop (horizontal width of extracted sections in Edge Crop
mode) of downconverter output.
–120 to 120 (0)
When 4:2:2 DUAL STREAM is selected, selects the signal output from the MON OUT HD SDI
connector.
Signals input from the HD SDI IN A connector are called "LINK-A signals", and signals input from
the HD SDI IN B connector are called "LINK-B signals".
LINKA [Link-A]: E-E output of the LINK-A signal, or playback output of the recorded signal
LINKB [Link-B]: E-E output of the LINK-B signal, or playback output of the recorded signal
A/B [Split(A/B)]: Screen split into 2 parts, with the LINK-A signal output to the left side, and the
LINK-B signal output to the right side
B/A [Split(B/A)]: Screen split into 2 parts, with the LINK-B signal output to the left side, and the
LINK-A signal output to the right side
FSEQ [Field Sequence]: Output the odd lines of LINK-A signals in field 1, and the even lines of
LINK-B signals in field 2.
When TYPE is set to "A/B" or "B/A", selects whether to display a dividing line between the
screens.
OFF [Off]: Do not display the line.
ON [On]: Display the line.
When BORDER is set to "ON", selects the luminance level of the border line.
0 to 110 (0)
Selects the input interface.
CAM [CAM(Optical)]: CAMERA connector (only when optional HKSR-101 is installed)
SDI [SDI Input]:HD SDI IN A/B connectors
selected under VA INPUT.
F950 [F950]: When using the HDC-F950.
STD [Standard]: When using the F23/F35. (The CA-F101 is required.)
D20 [D-20]: When using the ARRI D-20 camera.
Contact a Sony service representative for details about cameras which can be connected with an
optical-fiber cable.
Note
The VIDEO Setup menu does not appear when the SRW-1
is docked on the F23/F35.