Connecting Reference Signals (Examples For When External Sync Is Required) - Sony SRW-1 Operation Manual

3-3-2 Connecting Reference Signals
Required)
Connect reference signals as explained below, depending
on how you want to use the system.
Connections to record signals from cameras, switchers, signal generators, etc.
In the SYSTEM Setup menu, set REFERENCE >MODE
to "Input" (see page 56), and then connect as shown below.
In the SYSTEM Setup menu, set
REFERENCE >MODE to "Input."
Connections to record using optical-fiber cable
To record using an optical-fiber connection between this
unit and the F23 (F35)+CA-F101 camera, with the
optional HKSR-101 installed in the SRPC-1, the first step
is to synchronize by supplying reference signals from this
unit to the F23 (F35)+CA-F101 over the optical-fiber
cable. Next, output signals from the synchronized F23
(F35)+CA-F101 are input to this unit, replacing the
reference signals of this unit.
If you do not want to input external reference signals to
this unit, set REFERENCE >MODE (see page 56) in the
SYSTEM Setup menu to "Input".
F23/F35 Digital Cinematography
Camera (with CA-F101 Optical
Fiber Camera Adapter)
(Examples for When External Sync Is
REF IN, GENLOCK IN
HD SDI IN A/B
(A only or A/B)
SRW-1 + SRPC-1
CCU
FC2-PD50/PD250 Optical-Fiber
Cable (optional).
Reference signals
Camera, switcher, signal
generator, etc.
HD SDI OUT A/B
(A only or A/B)
When you need to input external reference
signals to this unit
Set REFERENCE >MODE in the SYSTEM Setup menu
to "External", and set REFERENCE >EXTERNAL to the
appropriate value for the reference signals that you are
using (see page 56).
If you want to input an HD tri-level sync signal to the REF
IN HD connector, set REFERENCE >EXTERNAL to
"HD" and make the connections shown below.
CAMERA
REF IN HD
SRW-1 + SRPC-1
+ HKSR-101 (optional)
Reference signals
In the SYSTEM Setup menu, set
REFERENCE >EXTERNAL to "HD".
3-3 About Reference Sync Signals
31