Table 5-19 Switch Setting For Sw2 On T1 Card - Panasonic DBS 576 Technical Manual

Chapter 5 - Trunks and Extensions
System Type
288 ports (Three Cabinets)
384 ports (Four Cabinets)
480 ports (Five Cabinets)
576 ports (Six Cabinets)
Installation
1. Align the CN8 connector of the CPC96 card or the CN5 connector of the
2. Insert the CPC96, TSW288, or TSW576 card in the specified slot.
3. Set the DIP switch (SW2-1) of the T1 card ON (trunk).
4. Set the DIP switch (SW2-2) of the T1 card as shown in Table 5-19.
Table 5-19. Switch Setting for SW2 on T1 Card
Switch No. Function
SW2-1 ON
OFF
SW2-2 ON
OFF
5. Set SW1 on the T1 card according to the following table.
5-26
TSW288 or TSW576 card with the holes of spacers and connect the SYNC
synchronization package. See Figure 5-8 on page 5-20 for how to install the
SYNC synchronization package.
Set to "Other mode". Can be used with the programmed number (1 to
16 or 1 to 24) of channels.
Set to "8-channel mode". Can be used with 1 to 8 channels.
These switch settings correspond to the distance between the DBS 576
and the CSU. To turn a switch on, set it to the "up" position.
DBS 576 (USA), issued 6/2/98
Maximum Cards
(available flexible
slot positions)
9/(1, 5, 9 3)
X
12/(1, 5, 9 4)
X
15/(1, 5, 9 5)
X
18/(1, 5, 9 6)
X
Section 300-Installation
Maximum Lines
(No. of channels)
9/(216ch)
12/(288ch)
15/(360ch)
18/(432ch)
576-13-300