Building Block Method (Wall-Mounting) Installation (576-Port Example Shown); Figure 4-6 Wall-Mounting Installation: Attaching The Wall-Mounting Bracket - Panasonic DBS 576 Technical Manual

Section 300-Installation
Building Block Method (wall-mounting)
Installation (576-port example shown)
Guidelines
Installation
1. Attach wall-mounting brackets on the rear of all cabinets that are to be installed.
Figure 4-6. Wall-mounting Installation: Attaching the Wall-mounting Bracket
Note: Base cabinet
Expansion cabinet-1 : cabinet installed on middle rack
Expansion cabinet-2 : cabinet installed on top rack
2. Temporarily fasten the 4 wall-mounting screws to the wall. (#10 flat head screws
3. Lift up the left Base cabinet, and hook it onto the 8 screws that are temporarily
576-13-300
CAUTION:
• When all 6 cabinets have been attached to the wall, the wall will be
subjected to a load of about 90 pounds. Before attaching the cabinets to
the wall, check the strength of the wall to make sure that it can withstand
this load.
The direction that the wall-mounting brackets are attached varies according to
the position (bottom, middle or top rack) where the cabinets are installed. Attach
the wall-mounting brackets according to the figures below.
: cabinet installed on bottom rack
recommended.)
fastening the wall-mounting angle.bracket.
DBS 576 (USA), issued 6/2/98
Chapter 4. - Installing Additional Cabinets
4-7