Mis Report Output; Table 6-5 Acd Card Sw1 Settings - Panasonic DBS 576 Technical Manual

Chapter 6. Peripheral Equipment

MIS Report Output

Guidelines
• Connecting a personal computer to the ACD card mounted on the flexible slot
• The RS-232C cable (supplied) is a 9-pin D-Sub connector. If the connection port
• When connecting the ACD card to a personal computer, regular communications
• The ACD card cannot be removed or attached with the power turned ON. Be sure
• The supplied cable will only work with ACD. The cable will not support SMDR
• For details on ACD, refer to "Section 520 ACD Reference Manual."
Installation
1. Set SW1 on the ACD card referring to the settings in Table 6-5.
Table 6-5. ACD Card SW1 Settings
Switch No. Setting
SW1 BACK UP
INITIAL
2. Slot the ACD card into flexible slot ( FS11).
3. Connect the 5-pin connector of the RS-232C cable (supplied) to CN3 on the
4. Pass the RS-232 cable through the wiring hole on the cabinet, and connect the
6-14
CAUTION:
• The back up battery will last about 5 years. Be sure to replace the
battery before it is exhausted.
using the RS-232C cable (supplied) allows output of MIS Reports from the
printer connected to the personal computer. You cannot connect a printer directly
to the ACD card for output.
on the personal computer or printer is a 25-pin D-Sub connector, connect via a 9-
pin/25-pin conversion adaptor.
software must be installed on the personal computer.
to turn the power OFF before removing or attaching the ACD card.
or PC Customization Tool.
Description
Set when retaining RAM data.
Set when clearing RAM data.
ACD card.
D-Sub 9-pin connector to the RS-232 port of the personal computer or printer.
If the connection port is a 25-pin D-Sub connector, connect via a 9-pin/25-pin
conversion adaptor.
DBS 576 (USA), issued 6/2/98
ACD card
Section 300-Installation
576-13-300