Chapter 6. Peripheral Equipment
Figure 6-4. Connections for D-SUB 9-pin to D-SUB 25-pin cable
• D-SUB 9-pin to D-SUB 9-pin
Figure 6-5. Connections for D-SUB 9-pin to D-SUB 9-pin cable
Installation
1. Set switch SW1 on the SCC card to the CTM position.
6-8
•
If your PC is equipped with a 9-pin D-SUB RS-232C connector, make a
cable as shown in Figure 6-5. The cable should be less than 50 ft. long.
See Figure 6-4for details of SW1 positions.
DBS 576 (USA), issued 6/2/98
Section 300-Installation
576-13-300