Table 6-4 Positions Of Sw1 On Scc Card; Figure 6-6 Connection To Pc - Panasonic DBS 576 Technical Manual

Section 300-Installation
Table 6-4. Positions of SW1 on SCC card
Switch No. Position
SW1 CTM
SMDR
2. Install the SCC card in one of the optional card slots.
3. Connect the 9-pin D-SUB connector on the RS-232C cable to the CN5
4. Pass the RS-232C cable through the wiring slot in the cabinet, then connect the
Figure 6-6. Connection to PC
576-13-300
Setting
Customization tool can be connected to RS-232C port (CN5)
Call logging device can be connected to RS-232C port (CN5) (default
when shipped)
connector (port 1) on the SCC card.
9-pin or 25-pin D-SUB connector on the other end to the RS-232C connector of
your PC.
DBS 576 (USA), issued 6/2/98
Chapter 6. Peripheral Equipment
6-9