Figure 6-23 Power Failure Unit Cable Punch-Out Plate And Wall Mounting - Panasonic DBS 576 Technical Manual

Section 300-Installation
Figure 6-23. Power Failure Unit cable punch-out plate and wall mounting
4. Connect the pin3 of CN5 (FG) to the earth.
5. Connect the SLTs to the AEC extension ports on the PFU.
6. Connect the trunks from the DBS 576 to the PFU.
7. Connect the AEC ports from the DBS 576 to the PFU.
8. Connect the +24V and GND terminals from the DBS 576 power unit to the PFU.
9. Install the cover on the PFU.
576-13-300
When a power failure occurs, AEC/8 card "A" line is switched to trunk
"A" line, AEC/8 card "B" line is switched to trunk "B" line, and so on.
DBS 576 (USA), issued 6/2/98
Chapter 6. Peripheral Equipment
6-27