Reducing Dust From Cutting Rolls - Canon imagePROGRAF iPF6400S User Manual

Reducing Dust from Cutting Rolls

• If you do not press "Finish paper set" after cutting the paper, you will not be able to print again.
Note
• Off
The edge is not cut and scraps are not removed.
Follow these steps to change the Trim Edge First setting.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
•
Note
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Trim Edge First, and then press the OK button.
6
Press ▲ or ▼ to select the desired setting option, and then press the OK button.
This setting takes effect the next time you load a roll.

Reducing Dust from Cutting Rolls

Reducing Dust from Cutting Rolls
For media such as Backlit Film that are more likely to generate debris when cut, select CutDustReduct. > On in the
Paper Menu of the Control Panel. This option reduces debris from cutting by printing black lines at the leading and
trailing edges of documents. It may help prevent Printhead damage. You can specify for CutDustReduct. to be activa-
ted for particular types of paper.
• Do not set CutDustReduct. to On for paper that wrinkles easily, such as Plain Paper or lightweight paper. This may impair
cutting and cause paper jams.
Important
• Borderless printing is not available when CutDustReduct. is set to On. To use borderless printing, select CutDustReduct. >
528
Off.
).
If the Tab Selection screen is not displayed, press the Menu button.
iPF6400S
User's Guide