Depression On The Leading Edge Is Left; Margins Are Wide - Canon imagePROGRAF iPF6400S User Manual

iPF6400S
In the Control Panel menu, Cutting Mode is set to Eject or Man-
ual.

Depression on the leading edge is left

Depression on the leading edge is left
Cause
Keeping a roll in the printer for a long time with-
out printing on it may leave a depression on the
leading edge.

Margins are wide

Margins are wide
Cause
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
When Cutting Mode in the Control Panel menu was set
to Manual, you selected Do not perform in response to
the "Perform the detection of paper leading edge?"
message.
User's Guide
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to On or
Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
This operation is normal.
Set Cutting Mode to Manual again, and select Perform(recommend) when the
"Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly curled,
the Printhead may rub against the leading edge of the paper when the printing
starts.
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
P.628
➔
Corrective Action
Depression on the leading edge is left
P.520
➔
947