Canon imagePROGRAF iPF6400S User Manual page 524

Specifying the Cutting Method for Rolls
Manual (for paper of which the leading edge rubs the printhead)
• Once the following step has been performed, the procedure can be started from step 10 the next time.
Note • Printing the second and subsequent times
• Printing after replacing with the same type of paper
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
•
Note
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6
Press ▲ or ▼ to select Manual, and then press the OK button.
7
When "Perform the detection of paper leading edge?" is displayed, select Do not perform.
•
Note
8
Press the Feed button.
524
).
If the Tab Selection screen is not displayed, press the Menu button.
If you set the detection of paper leading edge to Do not perform, a margin of about 23 cm is created at the paper
leading edge when printing starts.
iPF6400S
User's Guide