Canon imagePROGRAF iPF6400S User Manual page 521

iPF6400S
• Automatic and Eject are valid only when you have selected Auto Cut > Yes in the printer driver.
Note • With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut.
• Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the preset
cutting mode.
• If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount before cutting
to prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some cases.
Cut rolls manually in the following cases:
Eject (when the paper surface is being scratched / to wait for ink to dry)
• When cutting wide printed documents after ejection, have two people support the documents. If the paper drops, printed
documents may be damaged.
Important
• Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing quality or
cause rough cut edges.
• Once the following step has been performed, the procedure can be started from step 7 the next time.
Note • Printing the second and subsequent times
• Printing after replacing with the same type of paper
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
• If the Tab Selection screen is not displayed, press the Menu button.
Note
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
User's Guide
).
Specifying the Cutting Method for Rolls
521