Chapter 2
Setup Procedure for Emulex Fibre Channel Cards
This chapter describes the procedures for "Installing the Driver and Setting Up the Server" and "Recognizing
the Logical Units" required to establish a connection between a server with Emulex Fibre Channel cards and
an ETERNUS DX/AF.
2.1
Workflow
Workflow
Installing the Fibre Channel Card Driver
Install the driver. Download the proper driver from the Emulex web-site as required.
"2.2 Installing the Fibre Channel Card Driver" (page 28)
•
Driver (downloaded from web-site)
•
•
Used for driver installation
Manual (downloaded from web-site)
-
Creating Various Management Tables
Enter the necessary information in the "WWN Instance Management Table for the Server", "WWN In-
stance Management Table for Storage System", and "Target Binding Table".
"2.3 Setting Up the Server" (page 31)
•
"Appendix A Various Management Table Templates" (page 82)
•
Editing the Configuration File
Set the driver parameters by editing the configuration file.
"2.3 Setting Up the Server" (page 31)
•
"2.5 Required Driver Parameters" (page 40)
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
27
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0