Parameter Initialize; Decimal Point - Omron E5CK User Manual

Scaling upper limit
Scaling lower limit

Decimal point

This parameter can be used only when voltage input or current input is selected as
the input type.
When voltage input or current input is selected as the input type, scaling is carried
Function
out. Set the scaling upper limit in the "scaling upper limit" parameter and the scaling
lower limit in the "scaling lower limit" parameter.
The "decimal point" parameter specifies the decimal point position of parameters
(set point, etc.) whose unit is set to EU (Engineering Unit).
Scaling upper limit, Scaling lower limit
Parameter
Scaling upper limit
Comment
Scaling lower limit
Decimal point : default : 0
Set Value
F Related article
3.2 Setting Input Specifications (page 3-3)
F Related parameter
See
"Input type" (setup mode)

Parameter initialize

Returns parameter settings to their defaults. However, note that the following
parameters are not affected by execution of this parameter:
"input type", "scaling upper limit", "scaling lower limit", "decimal point" and
Function
"_C/_F selection".
When this parameter is selected, [
ters, press the
Example
of use
Setting Range
Scaling lower limit +1 to 9999
-1999 to scaling upper limit -1
Setting
0 0 digits past decimal point
1 1 digit past decimal point
2 2 digits past decimal point
3 3 digits past decimal point
key to specify [
Setup Mode
Conditions of Use
The input type must be set to analog input
(voltage or current input).
Unit
EU
EU
Example
1234
123.4
12.34
1.234
] ("no") is first displayed. To initialize parame-
] ("yes").
Default
100
0
5--23