Omron E5CK User Manual page 91

CHAPTER 5 PARAMETERS
Option Mode
The parameters in this mode can be used only when the "security" parameter (pro-
tect mode) is set to "0" and "1".
You can select this mode only when the option unit is set in the controller. In this
mode, you can set the communications conditions, transfer output and event input
parameters to match the type of option unit set in the controller.
To select this mode when in the levels 0 to 2, setup, expansion and calibration modes,
press the
If you select [
mum, the controller enters the option mode.
To select parameters in this mode, press the
use the
The following table shows the parameters supported in this mode and the page where
the parameter is described.
5--32
key for 1 second minimum. The display changes to the menu display.
] using the
or keys.
Symbol
Multi-SP function
Event input assignment 1
Communication stop bit
Communication data length
Communication parity
Communication baud rate
Communication unit No.
Transfer output type
Transfer output upper limit
Transfer output lower limit
key then press the
key. To change parameter settings,
Parameter Name
key for 1 second mini-
Page
5-33
5-33
5-34
5-34
5-34
5-34
5-34
5-35
5-35
5-35