Mounting - Omron E5CK User Manual

J Mounting
About the Terminal
Cover
(1) Insert the E5CK controller into the mounting hole in the panel at the
position shown in the figure above.
(2) Push the adapter along the controller body from the terminals up to
the panel, and fasten temporarily.
(3) Tighten the two fixing screws on the adapter. When tightening
screws, tighten the two screws alternately keeping the torque to
approximately 0.29 to 0.39 N·m, or 3 to 4 kgf·cm.
E5CK-AA1-500 controller is provided with a terminal cover (E53-COV07). Fasten
the terminal cover as follows by using the snap pin.
Adapter
2.2 Installation
Panel
Watertight
packing
2--5